Kiln Problems

I had a short in with one of the wires in my kiln which caused some of the wiring to melt.  Not a good odor to smell when you go to check on the kiln.  Finally received from Aim Kilns a new wiring harness and power chord after waiting a couple weeks.  Aim has always been very helpful and timely in the past so this one time waiting was a little frustrating while pieces were ready to be fired.  Electrical work is always a learning experience for me but I got it wired properly....I think?  We will see when I refire the load that is in the kiln from when it shut done early.